Leuco - Trimming Saw Blades HW with Chip Limiter "WS"

Brand: Leuco

MACHINE / APPLICATION

Table saws.

Special saws.

For sizing cuts in solid woods.

Especially for knotty woods.

DESIGN

Tooth configuration: alternate top bevel "WS".

Cutting material: HW HL Board 10.

ADVANTAGES

No chipped edges from knots thanks to chip limiter.

Noise-reduction thanks to laser ornaments.

NOTES

Larger bore (max. Ø 50 mm) available for a surcharge.

Product Variation:

LE1101420189946

Feature                                    Value

Ø D = Cutting circle diameter   250 [mm]

B = Cutting width                     3,2 [mm]

b = Body thickness                  2.2 [mm]

Ø d = Bore diameter                30 [mm]

Z = No. of teeth                       24       

NL = Pin holes                         2/7/42 + 2/9,5/46,5 + 2/10/60

Hook angle = Hook angle         20 [°]

Corner∡ = Corner angle          10 [°]

Tooth geometry = Tooth configuration            WS

LEUCODUR = Cutting material            HL Board 10

LE1101420189947

Feature                                                            Value

Ø D = Cutting circle diameter                           300 [mm]

B = Cutting width                                             3,2 [mm]

b = Body thickness                                          2.2 [mm]

Ø d = Bore diameter                                        30 [mm]

Z = No. of teeth                                               28

NL = Pin holes                                                 2/7/42 + 2/9,5/46,5 + 2/10/60

Hook angle = Hook angle                                 20 [°]

Corner∡ = Corner angle                                  10 [°]

Tooth geometry = Tooth configuration              WS

LEUCODUR = Cutting material                         HL Board 10

LE1101420189949

Feature                                                            Value

Ø D = Cutting circle diameter                           350 [mm]

B = Cutting width                                             3,5 [mm]

b = Body thickness                                          2.5 [mm]

Ø d = Bore diameter                                        30 [mm]

Z = No. of teeth                                              32

NL = Pin holes                                                 2/7/42 + 2/9,5/46,5 + 2/10/60

Hook angle = Hook angle                                 20 [°]

Corner∡ = Corner angle                                  10 [°]

Tooth geometry = Tooth configuration                WS

LEUCODUR = Cutting material                           HL Board 10